YONGLI hammer mill/Grinder feeding operation should be uniformed, ensure the motor at rated load.
 Opening the free door is prohibited in the production process. In the normal production process,
opening any coupling guards is forbidden.
Grinder during operation if unusual noise or blocked discharge, bearings or motor overheating, should stop feeding,
cut off the power, check until the rotor stops, troubleshooting. After the work is completed, must be idle for 2 minutes,
the machine crush the material completely discharged before being shut down. Instead shutdown and startup
sequence. After the shutdown of the mill be down to check, identify problems promptly resolved. It must be cleaned
of magnetic impurities mill entrance magnetic board.

                      

 Mill maintenance should be strictly in accordance with the rules to operate, the class must make the necessary
checks. You should always check on the cotter pin, if excessively worn or broken, replace it immediately. It should
be regularly inspected, cleaned (100 hours) and lubricate the bearings. Machine parts found severe wear and damage
should immediately repair and replacement of the rotor after the repair should be balancing test. Class after work, both
inside and outside the machine should be cleaned to remove dust and dirt in order to avoid rusting machinery, sieve
clogged inner bearing into the dirt.

                         Home >>> Biomass Grinder >>> Feed Hammer Mill  >>> Project Cases