yonglilogo
Pellet Roller Installation

YONGLI pellet mill roller Installation Notes:
1. Roller bearing should be installed in place, whether elastic appropriate, the impact of loose granulation effect,
    will result in tight rolls off dead.
2. Check the roller ring, doors are in place, in particular, to prevent the pressure roller door has a prominent
    phenomenon.
3. Check whether the pressure roller of the eccentric shaft has blocked phenomenon prevent bearing grease
    burn problem.

4. Check the pressure roller eccentric shaft rear end position of the journal and the spindle hole of the roll wear is
    beyond the technical requirements of machinery.
5. Check the contact gap between the pressure roller and ring mold, to ensure consistent contact pressure roller
    and ring mold.
    Based on the above principles of installation, YONGLI roll proved to be effective in actual use

4. Check the pressure roller eccentric shaft rear end position of the journal and the spindle hole of the roll wear is
    beyond the technical requirements of machinery.
5. Check the contact gap between the pressure roller and ring mold, to ensure consistent contact pressure roller
    and ring mold.
    Based on the above principles of installation, YONGLI roll proved to be effective in actual use.

1647845230487382.jpg