yonglilogo
Home > News >
Attention to pellet mill roller installation

                                        

YONGLI pellet mill roller Installation Notes:

1. Roller bearing should be installed in place, whether elastic appropriate, the impact of loose granulation effect,

    will result in tight rolls off dead.

2. Check the roller ring, doors are in place, in particular, to prevent the pressure roller door has a prominent

    phenomenon.

3. Check whether the pressure roller of the eccentric shaft has blocked phenomenon prevent bearing grease

    burn problem.

                                                    

4. Check the pressure roller eccentric shaft rear end position of the journal and the spindle hole of the roll wear is

    beyond the technical requirements of machinery.

5. Check the contact gap between the pressure roller and ring mold, to ensure consistent contact pressure roller

    and ring mold.

    Based on the above principles of installation, YONGLI roll proved to be effective in actual use.